PDF Download

ATON DLA4 PDF

Search among more than user manuals and view them online Find great deals for Aton DLA4 Four Room Speaker Switch With Volume Control. Shop with confidence on eBay!. Free Shipping on many items across the worlds largest range of Aton Dla4 In Home Audio Equalizers. Find the perfect Christmas gift ideas with eBay.

Author: Brasho Arashilrajas
Country: Martinique
Language: English (Spanish)
Genre: Travel
Published (Last): 17 October 2012
Pages: 233
PDF File Size: 5.61 Mb
ePub File Size: 19.55 Mb
ISBN: 736-9-65835-744-9
Downloads: 42441
Price: Free* [*Free Regsitration Required]
Uploader: Neran

Warranty service requests made without proof of date of purchase will be denied. Speakers rated between 4 Ohms and 8 Ohms can be matched with ampliers also rated from 4 to 8 Ohms.

ATON DLA4 Stereo Receiver User Manual

Press Play, turn ON, etc. Mild to moderate IR Flooding.

Use Rack screws not included to attach the assembled unit to the equipment rack as shown in Figure D Carefully peel the appropriate Room Identication Doa4 from the card and place it in the Room Label Location for the chosen room.

Speakers out of phase Carefully check polarity of each speaker 3. Local Commands control only one room at a time.

This is a single-source application: Verify that the impedance levels of dlx4 amp and speaker are not lower than 8 Ohms. If the volume level prior to turning the room off is lower or equal to the Maximum Turn-On Volume Level, the room will come back on at the last volume. Press the Room Button for the desired room.

  JBL CM62 PDF

Make sure to match the impedance of the speakers and ampliers as noted. Lift up each ip-lock connector until it is locked in the up position. The foregoing warranties do not cover reimbursement for labor, transportation, removal, installation or other expenses which may be incurred in connection with repair or replacement. IR signal not reaching Room input. Once the Scene Preset has been saved, the Room LEDs for the rooms included in the Scene Preset will blink on and off four times and the system will return to the levels prior to setting the Scene Preset.

Set the Zone 2 volume level to the point where it achieves the maximum listenable level prior to distortion.

ATON Stereo Receiver DLA4 User Guide |

Check Room IR receiver and verify wiring. Figure and Table provide description and location of Rear Panel connections. Programming additional remotes can be accomplished in a matter of seconds. Follow these guidelines to ensure your device is preserved and protected. Figure and Table provide descriptions and locations of Front Panel controls and indicators. Remote Control Options Option 1: Atob the volume in each room to the desired level.

Most speakers are 4 or 8 Ohms. However, there is no guarantee that interference will not occur in a particular installation.

ATON DLA4 manuals

Add an optional RF remote and receiver in order to have full control anywhere in the house. Increase the separation between the equipment and receiver. Turn a knob, and the volume goes up or down. Dl4 exist for IR, Ground, and Voltage.

  EDEN FOREST AOIFE MARI SHERIDAN PDF

Remote Control batteries are dead. IR Control No source control dla any Room. For more information and purchase options, visit our website at: Without releasing the Room button, press and hold the Vol – Button.

Source IR Emitters unplugged or defective. Room appears to be on and selected but unabled to be controlled using front panel buttons.

Aton DLA4 Four Room Speaker Switch With Volume Control

If the volume level prior to turning the room off is higher than the Maximum Turn-On Volume Level, the room will come back on at the Maximum Turn-On Volume Level instead of the last volume. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the dla44 is encouraged to try to correct the interference by one or more of the following measures: Reconnect or test with known good IR Emitters.

At bedtime, turn off the audio throughout the entire house. Adjust the volume as required. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Protect the power supply cord from being walked on or pinched, particularly at plugs, outlets and the point where they exit from the apparatus.

Push xla4 button – your speakers come on.